Vulcan 12 Instrukcja Użytkownika

ITW Food Equipment Group, LLC 10405 Westlake Drive Charlotte, NC 28273 RETAIN THIS MANUAL FOR FUTURE USE FORM F38201 Rev. C (11-11) INSTALLATION &a

- 10 - 4. Ensure that blower cover is assembled such that air deflector is to the bottom side of the oven. (See picture below). 5. Remove protect

- 11 - HOT TOPS The hot tops are coated with oil as a rust inhibitor. Remove this film when the hot tops are being cleaned prior to its first cookin

- 12 - GAS CONNECTIONS All gas supply connections and any pipe joint compound used must be resistant to the action of propane gases. Prior to lig

- 13 - Oven Thermostat — Regulates oven temperature. The thermostat temperature range is from LOW at approximately 250°F (121°C) to HI at appro

- 14 - Open Top - Pilot access can be reached under the grate support beam running from left to right. Manual Griddle – Pilot access can be re

- 15 - OVEN SECTION Standard Oven with Standing Pilot, Convection Oven with Standing Pilot 1. Turn thermostat to OFF position. 2. Turn the main g

- 16 - Thermostatic Griddle Pre-heat the griddle top for approximately 15 - 20 minutes before cooking. The griddle thermostats regulate temperature

- 17 - DAILY CLEANING Oven Remove chrome-plated racks and clean in a sink. While still warm, wipe top with a soft cloth or other grease absorbi

- 18 - General Cleaning Use ordinary soap or detergent and water for routine cleaning of stainless steel. To prevent water spots and streaks, rinse t

- 19 - TROUBLESHOOTING OVEN PROBLEM CAUSES / CORRECTIONS Uneven Baking Side to Side Range not level side to side. Oven burner or bottom improperly i

- 2 - IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL

- 20 - NOTES FORM F38201 Rev. C (11-11) PRINTED IN THE U.S.A.

- 3 - INSTALLATION, OPERATION AND CARE OF VULCAN ENDURANCE / WOLF CHALLENGER MODULAR SERIES GAS RESTAURANT RANGES PLEASE KEEP THIS MANUAL FOR FUTURE

- 4 - VFLANGED-FEET/4 Set of four (4) flanged feet. Two (2) sets required for 48", 60", and 72" ranges. CURBMNT-XL4 Curb mounting kit

- 5 - LOCATION The equipment area must be kept free and clear of combustible substances. Installation clearances: COMBUSTIBLE NON-COMBUST

- 6 - NOTE: In the Commonwealth of Massachusetts All gas appliances vented through a ventilation hood or exhaust system equipped with a damper o

- 7 - Ranges mounted on casters must use a flexible connector (not included) that complies with the Standard for Connectors for Movabl

- 8 - obstruction of the flue will result in voiding of warranty. It is recommended that the flue gases be ventilated to the outsi

- 9 - Re-install the Grate Castings along the front edge of the range. MOTOR ASSEMBLY INSTALLATION INSTRUCTIONS 1. Remove the oven racks and t